英国灵巧Rycote录音话筒专用防震支架invision usm 044901多功能减震架(注:此减震架相当于多用支架,可以夹任何口径大膜片录音话筒,兼容纽曼U87,TLM103等各型号话筒)
RYCOTE 044901 INVISION USM MICROPHONE SUSPENSION Studio mount series此减震架能兼容:纽曼、森海塞尔、舒尔、AKG、铁三角、RODE、德律风根、JZ等品牌各种录音膜片话筒。 减震架口径可根据话筒的粗细灵活自如的调节,一经固定,非常稳固耐用,保护话筒使其真正还原话筒声音本色。 A series of Rycote suspensions designed to offer protection against noise incurred by movement whilst on stand, handheld, or on boom pole. These suspensions are popular amongst TV and film sound engineers.
InVision USM series studio mounts use Rycote’s patented ‘Lyre’ technology to suspend studio microphones safely, and isolate them from the low-frequency thumps and rumbles that are transmitted through microphone stands. Due to the superior self-damping of the ‘Lyres’ they offer much better isolation across the whole audio spectrum, particularly in the 40-70 Hz region, than conventional elastic suspensions, which can sometimes have a negative effect at these critical frequencies, if not matched to the particular microphone. The mounts are designed to provide equal isolation around 360 degrees and are thus suitable for all side-address microphones; omnidirectional, cardioid or figure-of-eight microphones can be oriented vertically or horizontally. Microphones are locked in the mounts by four soft, rubber grips on the end of precision-made stainless-steel thumbscrews with ridged plastic heads. The screws can be adjusted by hand to fit almost any shape and profile within 18-55 mm. The grip surface of the pads allows the mounts to hold the microphone securely, even when positioned head-down, with minimal pressure from the screws. Note that microphones must be fitted into the mounts so that their centre of gravity is close to the level of the outer ring of the mount.
RYCOTE 044901 INVISION USM 麦克风悬挂工作室安装系列一系列 Rycote 悬架设计用于防止在站立、手持或悬臂杆上移动时产生噪音。这些悬架在电视和电影音响工程师中很受欢迎。 InVision USM 系列录音室支架使用 Rycote 的专利“Lyre”技术来安全地悬挂录音室话筒,并将它们与通过话筒支架传输的低频重击和隆隆声隔离开来。由于 'Lyres' 具有自阻尼能力,它们在整个音频频谱上提供了更好的隔离,特别是在 40-70 Hz 区域,比传统的弹性悬架有时会在这些关键频率产生负面影响,如果与特定麦克风不匹配。安装座旨在提供大约 360 度的同等隔离,因此适用于所有侧向麦克风;全向、心形或八字形麦克风可以垂直或水平放置。 麦克风通过制造的带脊状塑料头的不锈钢指旋螺钉末端的四个柔软橡胶把手锁定在安装座中。螺钉可以手动调整,以适应 18-55 毫米范围内的几乎任何形状和轮廓。垫子的抓握表面使安装座可以牢固地固定麦克风,即使在头朝下放置时,螺钉的压力也很小。请注意,麦克风须安装到安装座中,使其重心接近安装座外环的水平。 等级 (1):高 常用规格: 悬挂重量:154g。总直径:120mm。长度:170 毫米。深度:70 毫米。悬挂旋转:175 度。螺纹:3/8 和 5/8 英寸。
|